Thought I was in the electric forum. I reposted the thread there.
| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Carving: converting cross section templates to a contour map http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=22715 |
Page 1 of 1 |
| Author: | James Orr [ Sat Jun 13, 2009 12:02 am ] |
| Post subject: | Carving: converting cross section templates to a contour map |
| Thought I was in the electric forum. I reposted the thread there.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|