| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| User of the LMI Vacuum Work Holder http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=21886 |
Page 1 of 1 |
| Author: | Chris aka Sniggly [ Fri Apr 10, 2009 4:55 pm ] |
| Post subject: | User of the LMI Vacuum Work Holder |
Just received it in the mail today. The gasket that comes with it does not come together in the ring on the vacuum plate. Is this a problem? It looks like they cut it too short. There is atleast an 3/16th's gap between the ends. |
|
| Author: | Bob Garrish [ Fri Apr 10, 2009 5:02 pm ] |
| Post subject: | Re: User of the LMI Vacuum Work Holder |
Yes, it is a problem, but it's easily fixable. If it's a soft foam gasket, just stretch it a bit and glue the ends together with CA. I like to spray the accelerator on one end and put the glue on the other. |
|
| Author: | Chris aka Sniggly [ Fri Apr 10, 2009 7:52 pm ] |
| Post subject: | Re: User of the LMI Vacuum Work Holder |
Thankya very large Mr. Garrish.....that's what I needed. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|