Official Luthiers Forum!
http://www.luthiersforum.com/forum/

How many board feet does it take to make a guitar?
http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=21854
Page 1 of 1

Author:  CptanPanic [ Wed Apr 08, 2009 3:52 pm ]
Post subject:  How many board feet does it take to make a guitar?

I was wondering how many board feet does it take to make an acoustic guitar?
Thanks,
CP

Author:  Bob Garrish [ Wed Apr 08, 2009 4:14 pm ]
Post subject:  Re: How many board feet does it take to make a guitar?

Just under 0.9

It's closer to 0.8 if you can find a piece of wood already shaped like a neck and a bridge.

The waste factor is quite large, though. I'd imagine there's someone around who produces enough 'blanks' to say what the cost is in actual raw lumber?

Author:  CptanPanic [ Wed Apr 08, 2009 4:57 pm ]
Post subject:  Re: How many board feet does it take to make a guitar?

Wow that is a lot less than I would have thought, but it makes sense. But yeah I really want to know how much including the waste.

Author:  Mark Groza [ Wed Apr 08, 2009 6:20 pm ]
Post subject:  Re: How many board feet does it take to make a guitar?

If you are resawing boards for the top and bottom.That would take 1.5 B.F.alone with waste.Then you have the sides at 1 B.F. and lining and braces.Then the neck would depend on if it's laminated or not.Laminated would take more.And don't forget the fretboard and bridge.so your talking over 3 board feet with unlaminated neck 0.50B.F. at least with waste.

Author:  truckjohn [ Fri Apr 10, 2009 6:25 pm ]
Post subject:  Re: How many board feet does it take to make a guitar?

Let's see....

A rough top set is about 1/2 board foot
A rough back/sides set is about 1 board foot.
A rough neck takes another 1/2 board foot or so
Linings, purflings, and bindings may add another 1/4 board foot...

So... I add up just over 2.25 board feet....


Good luck

John

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/