| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Truss Rod Adjusting Nuts http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=21774 |
Page 1 of 1 |
| Author: | Cal Maier [ Fri Apr 03, 2009 9:15 am ] |
| Post subject: | Truss Rod Adjusting Nuts |
Does anyone know of a supplier for Truss Rod adjusting nuts? I make my own single action truss rods and my original supply is almost gone. The nut size is Length-3/4", Diameter-1/4", Threadsize-10-32, and it uses a 5/32" allen key wrench. Thanks, Cal |
|
| Author: | Howard Klepper [ Fri Apr 03, 2009 1:35 pm ] |
| Post subject: | Re: Truss Rod Adjusting Nuts |
Stew Mac |
|
| Author: | woody b [ Fri Apr 03, 2009 2:37 pm ] |
| Post subject: | Re: Truss Rod Adjusting Nuts |
http://www.lmii.com/CartTwo/thirdproducts.asp?CategoryName=Truss+Rods%2FNeck+Parts&NameProdHeader=Truss+Rod+Nuts LMI has exactly what you want, except the allen size is 1/64" smaller. |
|
| Author: | Cal Maier [ Fri Apr 03, 2009 6:36 pm ] |
| Post subject: | Re: Truss Rod Adjusting Nuts |
Thanks for the replies. Howard I checked with SM but the ones they carry are for Fender and Gibson and I was looking for the type similar to Martin, it's a smaller diameter barrel. Woody, that looks like the type I'm after, thanks for the link. Cal |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|