I hate using clamps for the shooting board, it takes too long etc... so I made this dealy, and it works pretty good. You just fit the plates, add the top brace, and 'flip the switch' and your locked! Now its fun to do!
| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Shooting Board Quick Release set-up! http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=20774 |
Page 1 of 1 |
| Author: | Frei [ Fri Jan 30, 2009 9:15 pm ] |
| Post subject: | Shooting Board Quick Release set-up! |
I hate using clamps for the shooting board, it takes too long etc... so I made this dealy, and it works pretty good. You just fit the plates, add the top brace, and 'flip the switch' and your locked! Now its fun to do!
|
|
| Author: | Zach Ehley [ Fri Jan 30, 2009 11:01 pm ] |
| Post subject: | Re: Shooting Board Quick Release set-up! |
I dont use any clamps. Well I do clamp my shooter board to the bench and then use my left hand to hold the board against the end stop.. It also doubles as my rosette cutter pin holder with a cavity to allow various size sound holes to be cut out. Its rather down and dirty made from extra MDF. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|