Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
1/8" collet for PC 310 laminate trimmer? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=20611 |
Page 1 of 1 |
Author: | Todd Rose [ Wed Jan 21, 2009 8:51 am ] |
Post subject: | 1/8" collet for PC 310 laminate trimmer? |
Is there a 1/8" collet for the PC 310, or is the only option to use a collet adapter? |
Author: | David Collins [ Wed Jan 21, 2009 8:57 am ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
None available that I'm aware of, but the the adapter collets Lee Valley sells seem to provide for a pretty true and solid centering. |
Author: | Jeffrey L. Suits [ Wed Jan 21, 2009 9:01 am ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
Todd Rose wrote: Is there a 1/8" collet for the PC 310, or is the only option to use a collet adapter? I've made adapters from telescoping hobby tubing. Slit each piece so it'll compress. You can also make template guide bushings, task-specific router bases, with it. |
Author: | Peter J [ Wed Jan 21, 2009 9:10 am ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
Todd, I had to get the adaptor bushing for mine. Here is the best price I could find: http://www.mlcswoodworking.com/shopsite ... rings.html |
Author: | Bob Garrish [ Wed Jan 21, 2009 12:28 pm ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
Precisebits has 1/4" bushings available at nominal cost for their 1/8" shank cutters (and they make the best cutters) so if you're looking to use anything in that range then that's the place to go. They also sell 1/8" collets for PC routers, but not the model you're speaking of. http://precisebits.com/ |
Author: | Todd Rose [ Wed Jan 21, 2009 12:38 pm ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
Thanks, everybody. I just ordered the StewMac adapter. BTW, did you know that both "adaptor" and "adapter" are correct spellings? ![]() |
Author: | Brock Poling [ Wed Jan 21, 2009 1:34 pm ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
McMaster Carr also sells them (3/16" too) |
Author: | Todd Rose [ Wed Jan 21, 2009 2:13 pm ] |
Post subject: | Re: 1/8" collet for PC 310 laminate trimmer? |
Thanks, Brock. Good to know. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |