Official Luthiers Forum!
http://www.luthiersforum.com/forum/

Wanting To Make 5 Piece Neck
http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=20358
Page 1 of 1

Author:  michaelt [ Tue Jan 06, 2009 11:27 am ]
Post subject:  Wanting To Make 5 Piece Neck

I'm interested in making a 5 piece neck.
I'm not having any luck locating a source for some 1/8" thick EIR. [headinwall]
Does anyone know of a supplier that handles thicker veneers?

Thanks,
Mike

Author:  Alexandru Marian [ Tue Jan 06, 2009 11:39 am ]
Post subject:  Re: Wanting To Make 5 Piece Neck

I am ignorant about laminated necks, are these center stripes supposed to be showing "face" grain, or side grain?! If side grain, offcuts from a back set sound perfect?

Author:  Barry Daniels [ Tue Jan 06, 2009 11:45 am ]
Post subject:  Re: Wanting To Make 5 Piece Neck

Get a side set from one of the suppliers. Then you will have a spare.

Author:  stan thomison [ Tue Jan 06, 2009 11:46 am ]
Post subject:  Re: Wanting To Make 5 Piece Neck

Just buy lowest grade cheapest rims/side set you can. Sand and glue. Can use on each side of anothere strip, use just one with other wood on either side,or just itself as a center strip.

Author:  Rod True [ Tue Jan 06, 2009 12:06 pm ]
Post subject:  Re: Wanting To Make 5 Piece Neck

Bob at RC Tonewoods or 2nd grade sides from Allied. You may have to email Bob for the request, it might not be on his website.

Author:  michaelt [ Wed Jan 07, 2009 12:27 am ]
Post subject:  Re: Wanting To Make 5 Piece Neck

Thanks for the ideas. I hadn't thought of finding some orphaned sides. [:Y:]

Mike

Author:  Shane Neifer [ Wed Jan 07, 2009 1:12 am ]
Post subject:  Re: Wanting To Make 5 Piece Neck

Mike I have EIR sides that have "issues" like some white blotches and things like that. I sell them for $5 each and are perfect for things like neck lamination contrast wood.

Shane

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/