Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
Bahco Cabinet Scraper, Two Different Sizes? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=20165 |
Page 1 of 1 |
Author: | archtop [ Wed Dec 24, 2008 1:03 pm ] |
Post subject: | Bahco Cabinet Scraper, Two Different Sizes? |
I could've sworn I saw the Bahco available in a thinner thickness than .32". Now I can't find it anywhere. Am I remembering correctly, because I've searched high and low. If anyone knows of a thinner one let me know. I think the one I have is too thick for what I do. In fact if you have a thinner Bahco maybe I'll trade you if you're looking for a thicker one. I've never used mine and it's never been burnished either. Otherwise, just point me to a place I can order one please. -John |
Author: | Barry Daniels [ Wed Dec 24, 2008 1:06 pm ] |
Post subject: | Re: Bahco Cabinet Scraper, Two Different Sizes? |
Google is your friend. http://www.amazon.com/Bahco-Sandvik-474 ... B0001ZONQG |
Author: | KiwiCraig [ Wed Dec 24, 2008 6:52 pm ] |
Post subject: | Re: Bahco Cabinet Scraper, Two Different Sizes? |
The L.M.I. set is the best I've come across . 4 card scrapers , .4 mm. , .6 mm . .8 mm. and 1 mm Swedish steel by Eberle |
Author: | TonyFrancis [ Thu Dec 25, 2008 5:20 pm ] |
Post subject: | Re: Bahco Cabinet Scraper, Two Different Sizes? |
- |
Author: | archtop [ Thu Dec 25, 2008 8:51 pm ] |
Post subject: | Re: Bahco Cabinet Scraper, Two Different Sizes? |
Barry Daniels wrote: And reading is yours. ![]() Amazon says that Scraper is quite stiff at .032". That's exactly the one I don't want. I'm actually best friends with Google and I'm still turning up zilch. I'm starting to think there is probably just one thickness available. Must be the old mind playing tricks on me that made me think there was a thinner one. -John |
Author: | Carey [ Fri Dec 26, 2008 12:27 am ] |
Post subject: | Re: Bahco Cabinet Scraper, Two Different Sizes? |
If the Bahco/Sandvik scraper is your preference, it is still available in .6mm/.024" from Duckworks Boatbuilders Supply for $7.50. I'm fairly sure there are other sources. I thought I saw it recently available with prepped edges for a couple of bucks more, but can't remember where... |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |