Thanks guys for the speedy replies!
| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Need install measurements for Gotoh 510s http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=20060 |
Page 1 of 1 |
| Author: | Ricardo [ Tue Dec 16, 2008 4:39 pm ] |
| Post subject: | Need install measurements for Gotoh 510s |
Can someone tell me the set back from edge of peghead and hole size for Gotoh 510's? Thanks |
|
| Author: | Michael Dale Payne [ Tue Dec 16, 2008 4:48 pm ] |
| Post subject: | Re: Need install measurements for Gotoh 510s |
as found on Stewmac's site Attachment: 7107_1spec.gif I set mine back .5625" 10mm brad point for the drill |
|
| Author: | Rod True [ Tue Dec 16, 2008 4:52 pm ] |
| Post subject: | Re: Need install measurements for Gotoh 510s |
I offset 1/2" from the edge. I use a 25/64" bit to drill for tuner holes. |
|
| Author: | Ricardo [ Tue Dec 16, 2008 4:56 pm ] |
| Post subject: | Re: Need install measurements for Gotoh 510s |
Thanks guys for the speedy replies!
|
|
| Author: | TonyKarol [ Tue Dec 16, 2008 4:56 pm ] |
| Post subject: | Re: Need install measurements for Gotoh 510s |
1/2 to 9/16ths offset .. 3/8 hole, then ream to fit. |
|
| Author: | Hesh [ Tue Dec 16, 2008 4:56 pm ] |
| Post subject: | Re: Need install measurements for Gotoh 510s |
Michael my friend is there any particular reason why you use .5625" as your set-back spec? |
|
| Author: | Rod True [ Tue Dec 16, 2008 5:22 pm ] |
| Post subject: | Re: Need install measurements for Gotoh 510s |
Because he's an engineer and thinks in decimal inches instead of fractions of an inch  I think the same way. 0.5625"=9/16" |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|