| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Source for CNC'ed bridges? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=19828 |
Page 1 of 1 |
| Author: | Michael Jin [ Fri Nov 28, 2008 9:47 pm ] |
| Post subject: | Source for CNC'ed bridges? |
I was wondering if there was any good sourced for CNC'ed guitar bridges. I'm not looking for anything fancy and I've just got very little interest in making these things by hand (and having them not come out REALLY symmetrical anyway). Any suggestions would be greatly appreciated. |
|
| Author: | Jim Watts [ Fri Nov 28, 2008 10:18 pm ] |
| Post subject: | Re: Source for CNC'ed bridges? |
Check with Rob Garish he might be just what your looking for. http://www.saintlutherie.com |
|
| Author: | Pat Foster [ Sat Nov 29, 2008 12:38 am ] |
| Post subject: | Re: Source for CNC'ed bridges? |
Also John Watkins at cncguitarparts.com |
|
| Author: | Rod True [ Sat Nov 29, 2008 2:49 am ] |
| Post subject: | Re: Source for CNC'ed bridges? |
Or you can buy a pre-made bridge from Stew-Mac or LMI. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|