| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Milling Very Narrow Cross-Grain Strips for Radial Purfling http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=17498 |
Page 1 of 1 |
| Author: | eugeniodilampp [ Fri Jun 06, 2008 8:34 am ] |
| Post subject: | Re: Milling Very Narrow Cross-Grain Strips for Radial Purfling |
Dear Mr. Todd, Very much thank you for your pictures. Now it all seems so clear. I will make some this weekend. Ciao, Eugenio |
|
| Author: | David R White [ Sun Jun 08, 2008 7:52 am ] |
| Post subject: | Re: Milling Very Narrow Cross-Grain Strips for Radial Purfling |
Thanks for posting those Todd. I think the radial purfling is a vrey cool look and I'm waiting for the right opportunity to use it. |
|
| Author: | LiquidGabe [ Sun Jun 08, 2008 11:45 am ] |
| Post subject: | Re: Milling Very Narrow Cross-Grain Strips for Radial Purfling |
When I'm cutting thin material I use a push / hold-down that covers the work entirely. I set the blade just proud of the work and let it cut into my push stick. This has the benefit of securing the offcut. Is there a safety issue with this I'm not aware of which caused you to choose your setup? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|